![]() Perhaps someone with a bit more experience than myself could add to this, but all of this is from my own experiences of working in the studio. The realm of producing vocals is very, very complicated, and takes lots of practice/experience. ![]() I personally haven't used it, but it's talked about a lot within my circle(trance and techno producers mostly). There's also the Trax V3 VST VST plugin I keep hearing about. Formant Correction In Pitch Shifting from Stephan Sprenger at Prosoniq. Sometimes this works really well, sometimes it does not. for time domain and spectral signal processing.similar to SoundHack. Also, most DAW's even have a function in which you can utilize a single sample Sampler that allows you to draw midi notes that will play the sample on key. It could be as simple as transposing the recorded audio clip in your DAW, though with warping, it can slow down or increase the speed of the audio clip. Personally I find it easier to use the VLP, as it allows me to get closer to the sound I want from the start. To be honest - you probably can do anything with a VLP(or the Boss unit you linked) in software with effects, filters(sidenote: check out some of the Fabfilter stuff if you are interested in software filters), vst's - but that just depends on how much time you have to do all the fx + processing. By the time you add appropriate eq'ing, compression, and reverb on the audio clip - you can't even really tell it was made from the unit. A common one a lot of folks get to do this is a VoiceLive Play, they aren't super expensive and do what they are made to do pretty well. You absolutely can utilize a piece of hardware that specifically has "gender" settings on it, as well as much more. Nectar is an all-in-one vocal processing plugin that uses AI. Besides being primarily a vocal chopping plugin, The Sauce is perfect for formant shifting as well. Is there a way to have just one instance of the plugin for the entire track, but to apply it only to specific items within the track, and with varying settings? I know I could just switch it all over to ReaTune, but I like the simplicity of ReaPitch.This is a great question that has several answers that are rather subjective, but I will give it my two cents in case you weren't aware of these options. MAutoPitch is a completely free AutoTune and formant shifter from MeldaProduction. Applying a separate instance of the ReaPitch plugin to every single item that needs it will drastically drain my computer's processing capabilities I believe. That means finally, that the well known Mikey Mouse and Darth Vedder effects are prevented as much as possible. ![]() As the mechanism, which 'shifts' the formant characteristics with the amount of pitch change. I would call formant shifting always in close connection with pitch shifting. Do I need to add a new instance of ReaPitch, separately to every single item within the one track that I want to use it on? Some of the items are just one syllable long. People often mismatch formant filters with formant shifters. I was going to change the shifter for these items to ReaPitch instead of "item properties", and then do the formant shifts to make them sound better. There is no formant shifter here, and these items sound awkward. The issue is with the items that were pitch-shifted using the shifter in "item properties". You can make the singer sound like a little girl or a Russian swimmer, but it’s still the same note on a scale. So lets say you move the formants without changing the pitch. ReaPitch has a manual formant shifter, and after applying that, these items sound good as well. Formant frequencies aren’t dependent on the fundamental frequency (pitch) of the note, they depend on the vocal tract of the singer. ReaTune seems to automatically adjust the formants, so those items sound fine. Sounds pretty good, but some of the pitch shifts sound awkward and I found out that this is because of the formants. So, I have 3 different pitch shifters being applied to different items. Finally, I found the ReaTune plugin and used that as well. I initially applied some pitch shifts to some items using the pitch shifter in the "item properties", then I subsequently discovered the ReaPitch plugin and applied that to other items. I have a vocal track sub-divided, or split into several different items.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |